Your satisfaction with your Pella windows and doors is our priority. Should you find a problem with your Pella product that you believe could be related to the window’s installation, taking the following steps may help determine if the product is installed level, square and plumb.
First, grab a level and place it on the frame of the product, across the bottom or sill. Do not put it on the sashes or panels of the product since it may not give an accurate reading. The bubble of your level should fall in the center, demonstrating the product is installed level.
Next, examine plumb of your window or door. Plumb means the window or door is straight down or up, vertically. To examine for plumb, set your level on the two vertical side jambs on the exterior face to ensure the product is plumb from the inside out. Then, you’ll check for plumb from left to right by placing the level on each of the two sides. The bubble should fall in the midpoint on both sides, representing that the product is installed plumb.
When you finish checking plumb, you can check for bowing by measuring the unit horizontally across the top, middle and bottom. The measurements of these three places should all be equal, plus or minus one eighth of an inch. It’s crucial to always measure to and from the same point on both sides for consistency. Finally, see if your window or door is square by measuring from corner to corner in an X fashion on the outside of the product. The measurements should be within 1/8 inch of each other, indicating the product is
You could also check the reveal, where the sash meets the frame. The gap should appear the same from top to bottom and left to right. Each side of your product should appear the same, signifying the product is installed level, square, and plumb.
Setting aside time to do a little troubleshooting on your own can offer helpful information to solve a problem. If it turns out that you have stumbled upon one, or even a couple, of these issues, visit the Pella Window and Door Showroom in Owensboro or give us a call at 270-684-3028.